Copyright/Copyclaim © 2010 E. Excelex All Rights Reserved www.hexahedron999.com
All information, articles, photos, images, research & technology posted on this page is copyrighted and copyclaimed by Mrs. E. Excelex CANADA
STEP 6
Re-
head of the unit … screwing it back into place by turning counter-
INSTRUCTIONS FOR CHANGING FILTERS
· Before turning the water off fill a bucket with a few liters of clean water for rinsing the unit.
· Place a bucket or bowl underneath the Filter to receive any outpouring of water from the unit
· Shut off water INLET valve to the unit
STEP 1
Press the white button (or red) on
top (head) of the Filter Canister
(or for under the counter model open kitchen faucet cold water). This is to release internal pressure in canister
STEP 2
Use the key wrench to
loosen up the canister
by turning clockwise …
then unscrew by hand
Removing the canister
from its head
STEP 3
Remove the filter
(white plastic or sediment)
from the outer unit
STEP 4
Rinse the filter housing in
the bucket of clear water
that you prepared before
starting.
STEP 5
Install the new filter(s) back inside the
larger outer (clear or blue) canister
Make sure that the large “O” ring is
well seated in the groove on top of
the canister ridges. You can add a
light coating of Vaseline to keep it more
flexible and in place
STEP 7
NOW open the water INLET tap … Press on white button (or red) on top of the Canister head to let the air out (or open cold water tap for under the counter model) Allow the water to run for a few minutes to rinse the unit and it is done
NOTE: water could leak from top button until pressure is built up in the canister. If so, shut off the cold water faucet for 15 seconds so that pressure will build up. If still leaking, release water pressure in canister (by presssing the white or red button) and tighten more the canister using key wrench. Never attempt to open or to seal tight the canister while it is under pressure … it would be useless.
